Description Had these made to help with undoing and tightening dashboard switches , those annoying aluminium switch nuts. These are made for genuine switches and reproduction as it seems repro switches the makers made up their own sizes and shapes of slots . The slotted ones are for switches that have a stalk coming out of them and the slotless ones are for hazard switches and light switches , the centre slot is so it can be used for clutch cable wing nut tightening .In the image with various arrows it should help explain the uses . This is the second generation of these I hopefully listened to feedback and made 3 changes to help improve it . Slotted for 12v switches that have a centre shaft coming out like wiper switches Slotted for 6v switches as above Slotted but flat edge this works well on the new reproduction switches that have just flat slots in them (I had to grind a small amount off the sides to fit into 1 type of repro switch ) So please you may need to alter to suit the switches you have . Non slotted will work on 12v 6v switches that have nothing getting in the way on the centre section PLEASE BE AWARE THAT YOU MAY NEED TO ALTER / TWEEK TO SUIT YOUR SWITCHES , UNFORTUNATELY NOT ALL SWITCH ESCUTCHEONS ARE THE SAME . These are stainless steel then rumbled to remove sharp edges .